Chapter 5. Trades & Technology - Construction And Building

1

MR Credit 4.1 specifies that only permanently installed materials can be included in the calculation, and that if furniture is included, it again, must be consistently applied through MR Credits 3-7

2

List the four stages of an ideal Rankin cycle

3

In ____-angle projection, the top view is shown below the front view, the left side view is shown to the right of the front view, and the right side is shown to the left of the front view.

4

____ is/are stronger than solid wood and is/are used for longer spans.

5

Bricks are available in a great number of sizes, but the Common Brick Manufacturers Association has adopted a standard size with the nominal dimensions of ____.

6

The permanent split-capacitor (PSC) motor ________

7

Name and describe the most common types of assemblies that are used in a complete set of working drawings.

8

What is an inverter used for?

9

Each of three equal capacitors in series has _____

10

The brazing process can be used successfully with Oxy-Fuel and GTAW processes on cast irons

11

Why is the constant rotational speed of the generator shaft important for certain wind turbines?

12

Name the symbol used when it is undesirable for the surface contour of a weld to be raised above the surface face.

13

Pole buildings are a variation of ____ construction.

14

Small appliances such as household refrigerators and freezers now primarily use:

15

Define residential air conditioning

16

Which of the following is a good suggestion when bending the furnace plenum flange to minimize distortion?

17

A breaker box is built as a square and covers 132.25 sq. in. of wall space. What is the width of the box?

18

Why is it important to measure the vacuum level on the system?

19

When using site-layout instruments, the readouts for angular measurements are typically expressed in _____

20

Legal Description: All that portion of Lot 12 of MARTIN’S ADDITION TO VISTA, in the County of San Diego, State of California, as shown on Map No. 1472, on file in the Office of the County Recorder of said San Diego County, described as follows: Beginning at a point of intersection of the Southeasterly line of said Lot 12, with a line drawn parallel with and distant 140.00 feet, measured at

in Trades & Technology

right angles Northeasterly from the Northeasterly line of Citrus Avenue, 60 feet wide, as shown on said Map No. 1472, said point being the Southeasterly corner of the land conveyed to William Allington by deed dated February 02, 1933, and recorded in Book 188 Page 391 of Official Records of said San Diego County; thence North 30 Degrees 18 Minutes West along the Easterly line of land so conveyed, being also the aforementioned parallel line, 186.45 feet to an angle point in said Easterly line; thence continuing along said Easterly line, being parallel with and distant 140.00 feet at right angles Easterly from the Easterly line of said Citrus Avenue, North 0 Degrees 22 Minutes East 141.97 feet to the TRUE POINT OF BEGINNING; thence continuing along said parallel line, North 0 Degrees 22 Minutes 100 East, 50.00 feet to a point distant thereon South 0 Degrees 22 Minutes West, 100.00 feet from the Southerly line of the Northerly 4.0 Acres of said Lot 12, as said Northerly 4.0 Acres were conveyed to H. B. Morris, et ux, by deed dated April 14, 1930, and recorded in Book 1784 Page 187 of Deeds; thence parallel with and 100.00 feet Southerly at right angles from said Southerly line of said Northerly 4.0 Acres as conveyed to said Morris, South 89 Degrees 38 Minutes East, 270.85 feet to a point in the centerline of Hillside Drive as shown on said Map No. 1472; thence along said centerline of said Hillside Drive, South 58 Degrees 28 Minutes West, 12.98 feet to an angle point in said centerline; thence continuing along said centerline, South 36 Degrees 42 Minutes West, 102.0 feet; thence leaving said centerline, North 78 Degrees 34 Minutes West, 203.46 feet to the TRUE POINT OF BEGINNING.

What will be an ideal response?

21

Although a factor to consider, the location of a building is not as important as its design.

22

It has been observed that "though Jackson was perhaps not himself a democrat, he was a democratic leader." Do you agree or disagree? What specific examples from Andrew Jackson's presidency illustrate or contradict the view of Jackson as a "democrat" and the view of Jackson as a "democratic leader"?

23

Which of the following do you think made the most important contribution to American national interests: Neutrality Proclamation, Washington's Farewell Address, or Convention of 1800? Justify your answer.

24

Specify the limits and tolerance for this dimension value: .500 ± .005 in.

25

What is an advantage of the oxyacetylene flame compared to air acetylene?

26

Dividing the total computed load in volt-amperes by the residential service voltage of ____________________ volts will give the minimum ampacity that the service conductors must be rated for.

27

One set of service entrance conductors is permitted to supply __________ service disconnecting means instead of a single main disconnect.

28

Whenever it is possible, the contractor will use the material excavated at the site for backfill requirements.

29

What is the best tool for determining if an electrical wire running through a space where you are working is energized?

30

What do straight lines on a simple payback curve imply?

31

Three facial features that may interfere with the seal of a respirator are:

32

With parts coming to a service facility from different parts suppliers, a way to keep track of them and help the production schedule is for the parts specialist to use__________ .

33

The change of scope or the addition of extra work is generally a(n) ____________________ type of change.

34

What system operating characteristics would you expect from a system that has a TEV with a dead power element?

35

Draw the symbol for a floor receptacle.

36

Conveyors do not need to be blocked off by barricades to prevent workers from trying to pass, step, or jump over them

Find your answers, solutions and more...

We made it much easier for you to find exactly what you're looking for on Sciemce. Enjoy our search engine "Clutch."

Save a GPA. Donate your notes with us.

Chapter 5. Trades & Technology - Construction And Building

Recent Packs