Question

What will be an ideal response?

Answer 1

Steering wheel free play is the amount of steering wheel movement before the front wheels begin to turn.

Answer 2

At the end of each working day

Answer 3

B

Answer 4

D. Unitized bodies are unique from other frame construction in that they have a steel box around the passenger compartment.

Answer 5

At the end of each working day

Answer 6

TRUE

Answer 7

Answer: A

Answer 8

Drive cycles follow a general pattern, but the specific drive cycle for each monitor type and manufacturer requires slightly different driving conditions. A drive cycle includes a cold engine key-on startup followed by a warm-up period at idle. The next phase is a moderate acceleration, cruise, followed by deceleration. A second idle period for one minute with another heavier acceleration is followed by a steady-state cruise and a final deceleration. Using a scan tool, you can access the Readiness Status menu to determine which monitors have run and which have not. Driving the vehicle while displaying the Readiness Status allows the driver to view the information as each monitor is run to completion.

Answer 9

235 mm

Answer 10

C

Answer 11

C

Answer 12

B

Answer 13

Ans: B. SMF,

Answer 14

E) All of the above

Answer 15

Answer: A

Answer 16

The choke is a winding of wire that acts as a high resistance to block noisy AC current but allows the DC current to pass normally.

Answer 17

A

Answer 18

Answer: B

Answer 19

How to repair:
 Allow correct flash time between coats
 If a coat is too wet, the technician should allow for the finish to flash before applying a second coat. Corrections in the spray gun adjustment and set-up can be made before the next coat.
 Cross-checking: Cross-checking means the technician will spray the panel in the opposite direction of the striped one. The technician should allow for proper flash time, after corrections to gun set-up have been made and a test pattern confirms that the spray pattern and adjustment is correct.
 Sand and refinish.
 If striping is severe, the finish will need to be reapplied.

Answer 20

A

Answer 21

True

Answer 22

D

Answer 23

C

Answer 24

Answer: B

Answer 25

C

Answer 26

Answer: C

Answer 27

D

Answer 28

D) Nested

Answer 29

a. Technician A only
Technician A only is correct because while the battery cannot discharge
through the plastic case, the concrete is cold and damp. If a battery is stored on concrete, the difference
in temperature between the top and bottom of the cells causes the battery to self-discharge. All batteries should be stored in cool dry locations. Technician B is not correct because even though a battery may self- discharge if stored on concrete, it can be charged on concrete as long as it does not remain on the concrete floor in storage after it has been fully charged. Answers c and d are not correct because Technician A only is correct.

Answer 30

C

Answer 31

C

Answer 32

C

Answer 33

False

Answer 34

chain drive

Answer 35

C

Answer 36

Answer: B

Answer 37

TRUE

Answer 38

Answer: D

Answer 39

Answer: C

Answer 40

B

Answer 41

True

Answer 42

Answer: A