Which of the following is true of FCAW?
A. When bevels are cut, the joint-included angle must be larger than 35 percent.
B. The addition of deoxidizers eliminates most of the precleaning required.
C. Welds cannot be made on plates with mill scale.
D. Edge-beveling preparation is required on all joints up to 1/2 inch.
Answer: B
You might also like to view...
?Which process is most suited to developing a deep thermoformed product?
A. ?matched-mold forming B. ?vacuum forming C. ?pressure-bubble plug-assist vacuum forming D. ?mechanical forming
List various types of sidings commonly used in buildings.
What will be an ideal response?
Do you think that President Carter overreacted to the Soviet invasion of Afghanistan? Why or why not? In what way did that event mark a critical turning point in American foreign policy?
What will be an ideal response?
?Given a harmonic with a fundamental power frequency of 60 hertz, what would be the frequency of the fourth harmonic?
A. ?120 hertz B. ?180 hertz C. ?240 hertz D. ?300 hertz