A P0753 diagnostic trouble code (DTC) means that the TCM has detected a fault with ________.

A) Input shaft 1 (odd number gear axle) speed sensor system
B) Input shaft 1 (odd number gear axle) speed sensor system (output high range out)
C) Line pressure solenoid system (open circuit)
D) Shift select solenoid 1 system (open circuit)


D) Shift select solenoid 1 system (open circuit)

Trades & Technology

You might also like to view...

Technician A says the waveform created by AC voltage is typically called a sine wave. Technician B says one complete sine wave is a cycle. Who is correct??

A. ?A only B. ?B only C. ?Both A and B D. ?Neither A nor B

Trades & Technology

Which of the following levels would not be a valid LOW for a TTL gate?

A) 0.1 V B) 0.7 V C) 1.0 V D) All are valid.

Trades & Technology

Galvanized iron pipe has been dipped in molten zinc to make it:

A) Resistant to water. B) Resistant to heat. C) More aesthetically appealing. D) Corrosion resistant.

Trades & Technology

When a general duty split-phase motor reaches approximately 75% of its operating speed, the start winding is de-energized by a ____.

A. circuit board B. capacitor C. centrifugal switch D. dual voltage switch

Trades & Technology