?Why would a welder stick the end of the filler rod in the weld pool as the weld is being stopped?
A. ?It accidentally happens sometimes but they would not do it on purpose.
B. ?To prevent dropping it when changing positions.
C. ?To help to prevent crater cracking.
D. ?It cools off the end of the filler rod to prevent oxidization.
Answer: C
You might also like to view...
What is the overall length of the 9/16 wide slots on the reducer bracket?
Review drawing number 523797C0A and then answer the question.
A cylindrical hole is drilled in a block, and a cylindrical piston is placed in the hole. The clearance is equal to one-half the difference between the diameters of the hole and the piston. The diameter of the hole is normally distributed with mean 15 cm and standard deviation 0.025 cm, and the diameter of the piston is normally distributed with mean 14.88 cm and standard deviation 0.015 cm. The diameters of hole and piston are independent.
a. Find the mean clearance. b. Find the standard deviation of the clearance. c. What is the probability that the clearance is less than 0.05 cm? d. Find the 25th percentile of the clearance. e. Specifications call for the clearance to be between 0.05 and 0.09 cm. What is the probability that the clearance meets the specification? f. It is possible to adjust the mean hole diameter. To what value should it be adjusted so as to maximize the probability that the clearance will be between 0.05 and 0.09 cm?
What is the abbreviation of the American National Standards Institute: ______________
Fill in the blank(s) with the appropriate word(s).
1 kWh is equivalent to
A) 3.6 × 106 J. B) 6.0 × 104 J. C) 6.0 × 103 J. D) 1.0 × 103 J.