A bolt is described as M8 X 1.5. Technician A says that the bolt is 8 mm long. Technician B says that this is an UNF bolt. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
D
You might also like to view...
Technician A says that a headlamp that does not illuminate due to high circuit resistance would be described as a "short". Technician B says that a blown fuse or tripped circuit breaker is always caused by a short to ground. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
The requirement that foundations must be built in excavations that are "in the dry" means that _____
a. water cannot be applied during compaction b. the excavations must be free of water c. work must be stopped on rainy days d. groundwater barriers must be installed
Technician A says that when checking the oil level on the dipstick of an Allison transmission and it reads full, the actual oil level should be slightly above the top of the oil pan. Technician B says that at the correct oil level reading, the actual oil level will be slightly above the planetary gearsets. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
The metal control hardware used to relieve stresses caused by expansion and contraction in large ceiling or
wall expanses in interior drywall systems is called a(n) _____. a. L-bead b. J-bead c. corner bead d. expansion joint