The height of garage doors is measured from the ____.

A. peak of the roof
B. driveway marker
C. floor level
D. line representing the ground


Answer: D

Trades & Technology

You might also like to view...

Failure to remove the root edge may result in ____.

A. porosity B. poor penetration C. a concave root surface D. grapes

Trades & Technology

Consumption supplies are the supplies used to:

What will be an ideal response?

Trades & Technology

Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says that a TP sensor can be tested using a DMM (digital multimeter), DSO (digital storage oscilloscope), or scan tool. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

In what circumstance would bare-pipe evaporators not be used?

A) air conditioning coils B) heat pump indoor coils C) Low-temperature refrigeration storage D) medium temperature walk in cooler evaporators

Trades & Technology