After a TP sensor has been tested using the min/max function on a DMM, a reading of 5 volts is displayed
What does this reading indicate?
A) The TP sensor is open at one point during the test
B) The TP sensor is shorted
C) The TP sensor signal is shorted to 5-volt reference
D) Both B and C are possible
D
Trades & Technology
You might also like to view...
How are stainless steels and heat-resisting steels classified?
What will be an ideal response?
Trades & Technology
After screeding, concrete should be further leveled by using a _____.
a. drag b. darby c. drift d. dilly
Trades & Technology
On some engines, what holds the cam in position during cranking?
A) Oil pressure B) A magnet C) Oil screens D) A locking pin
Trades & Technology
Wood shingle and shake roofing can be made from many species, but ____ is the most commonly available.
A. oak B. maple C. pine D. cedar
Trades & Technology