The __________ the number of poles used in a stepper motor, the better the resolution.
A. smaller
B. larger
Answer: B
You might also like to view...
On a drawing 1/2 inch represents 1 inch, if the measurement of an isometric CAD drawing is 2 5/16 inches, determine the actual length to the nearest 1/8 inch.
What will be an ideal response?
All of the following are part of cylinder reconditioning EXCEPT ____.
A. resurfacing B. boring C. honing D. sleeving
Technician A says that the hybrid Silverado/Sierra do not use conventional starters or alternators. Technician B says that these units were replaced with a three phase AC electric motor to do the job of both. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
When are two shafts in perfect alignment?
A. only slight angular misalignment exists. B. shaft center lines coincide. C. shafts are perpendicular to each other. D. runout reading is less than .001 inch.