The G-code to set the machine to millimeter units is:
A. G21
B. G20
C. G17
D. G16
Answer: A
You might also like to view...
A drafter needs to understand the engineering formulas that are used in a basement seismic design.
Answer the following statement true (T) or false (F)
If a boiler will be subjected to freezing temperatures during an extended shutdown, it is normally placed in _____.
a. wet storage b. either dry or wet storage c. dry storage d. dry storage and kept warm by heaters
When a canvas collar (vibration eliminator) is properly installed between two duct sections, the metal surfaces of the ductwork should be rubbing against each other.
Answer the following statement true (T) or false (F)
Technician A says that most HEVs use a special hybrid fuel injection system to deliver fuel to the internal combustion engine. Technician B says that HEVs use an ignition system to fire the spark plugs of the internal combustion engine. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician