A) 100-200 ms
B) 1-3 seconds
C) 450-550 ms
D) Less than 100 ms
B) 1-3 seconds
C) 450-550 ms
D) Less than 100 ms
When a process technician wants a control loop to keep the process near the actual set point, he/she will set the controller in:
a. AUTO
b. MANUAL
c. CASCADE
Answer: A
Trades & Technology
You might also like to view...
In general, the sidewall load on any raceway run should not exceed _____.
a. 100 pounds/foot of bend b. 200 pounds/foot of bend c. 350 pounds/foot of bend d. 500 pounds/foot of bend
Trades & Technology
____ is lumber used for general building purposes.
A. Shop lumber B. Yard lumber C. Finish lumber D. Factory lumber
Trades & Technology
When testing an O2S (Oxygen sensor) using a DSO (digital storage oscilloscope), how quickly should the voltage change when either propane is added to the intake stream or when a vacuum leak is created?
Trades & Technology
Two types of location tolerance are:
A. Position and concentricity B. Position and parallelism C. Concentricity and flatness D. Straightness and flatness
Trades & Technology