If a #1157 bulb were installed in a left front parking light socket instead of a #2057 bulb, what would be the most likely result?
A) Left turn signal would flash slower B) Left parking light would be slightly brighter
C) Left parking light would be slightly dimmer D) Left turn signal would flash faster
B
You might also like to view...
Use ____ lines or the RAY option to lay out the location of the stem wall, footings, doors, and fireplace for a concrete slab foundation plan.
A. presentation B. dimension C. construction D. setup
The coils in a runaround loop system are installed in the exhaust duct and supply duct. Installation of the coils in these locations gives _____.
a. no temperature difference between the airstreams flowing in the ducts b. the greatest temperature difference between the airstreams flowing in the ducts c. the minimum temperature difference between the airstreams flowing in the ducts d. a greater recovery efficiency for the cooling cycle than for the heating cycle
How is floral foam (OASIS®) used in the construction of centerpieces, and how is it
prepared before it is used?
What will be an ideal response?Which of the following statements is true?
A rigid, adiabatic vessel is initially evacuated. 10 moles of liquid A and 10 moles of liquid B at 298.15 K are injected into the vessel, and this 20 moles of liquid is regarded as the “initial state” of the system. When the vessel reaches equilibrium, both a liquid and a vapor phase are present, and the entire equilibrium VLE mixture inside the vessel is regarded as the “final state” of the system. The reaction A+B?C+D occurs in the liquid phase, but not in the vapor phase. The equilibrium constant for the reaction is 0.4 and the reaction is exothermic. The vapor pressures are 0.12 MPa for compound A, 80kPa for compound B, 0.15 MPa for compound C and 70kPa for compound D. The vapor phase can be modeled as an ideal gas, but the liquid phase can NOT be modeled as an ideal solution.