What is the output voltage at the end of the input pulse to an RL integrator if the resistance is 1 k?, the inductor is 1 H and the input is a 22 V, 2 ms pulse?
A) 21.6 V B) 13.9 V C) 20.9 V D) 19.0 V
D
You might also like to view...
What component on a Paccar MX-Series engine using EUP fueling enables the engine electronics direct control of fuel injection events and pressures?
A. rail pressure control valve B. rail pressure sensor C. EUP actuator D. SMART injector
A technician connects one lead of a digital voltmeter to the positive (+) terminal of the battery and the other meter lead to the battery terminal (B) of the starter solenoid and then cranks the engine. During cranking, the voltmeter displays a reading of 878 mV. Technician A says that this reading indicates that the resistance of the positive battery cable is too high. Technician B says that this reading indicates that the starter is defective. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
A numbering system that contains only two digits is called a ________ system
A) Hexadecimal B) Base 10 C) Volatile D) Binary
Select the response that best defines the use of the Master Reset (MR) on typical counter ICs
A) The MR is a synchronous active HIGH input that resets the counter to 00002 on the next input clock pulse. B) The MR is an asynchronous active HIGH input that resets the counter to 00002 on the next clock pulse input. C) The MR is a synchronous active HIGH J-K input that resets the counter to 00002. D) The MR is an asynchronous active HIGH input that resets the counter to the 00002 state.