Which G-code program would be correct if the tool is starting at (2.5,10,4) and ending at (4, 11,4), using absolute programming and the currently set feed rate:

A. G90 G01 X4 Y11
B. G90 G00 X4 Y11
C. G90 G01 X1.5 Y1
D. G91 G01 X4 Y11


Answer: A

Trades & Technology

You might also like to view...

If your truck or bus has dual parking control valves, you can use pressure from a separate tank to:

a. Stay parked twice as long without using up service air pressure. b. Balance the service brake system when you are parked. c. Release the spring emergency/parking brakes to move a short distance.

Trades & Technology

The total surface area of a pyramid or cone equals one-half the product of the perimeter of the base and the slant height.

Answer the following statement true (T) or false (F)

Trades & Technology

Technician A says that all vehicles from the same manufacturer use the exact same power steering fluid. Technician B says that some fluids may be incompatible with system seals. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

Natural ventilation can be provided in a building ________________________

A. through open windows that allow air to move across the floor B. via a stack effect which relies on the fact that warm air will rise and pull in outside air to replace the amount of air removed C. by heating the return air and cooling the supply air D. Both A and B

Trades & Technology