Which of the following should not be done when changing the engine fuel filters?
A. Tighten the secondary fuel filter until the rubber gasket makes contact with the filter base; then tighten and additional half turn.
B. Install the primary fuel filter and spin it on, leaving the filter loose.
C. Fill both the primary and secondary filter with fuel before installation.
D. Operate the manual hand pump located on the injection pump until fuel bubbles surround the top of the primary filter.
Answer: C
You might also like to view...
A geothermal system uses 3 wells. Each well is 76 feet deep. Find in feet, the total length of well drilling.
Fill in the blank(s) with the appropriate word(s).
Technician A says that a visual inspection can determine if brake linings contain asbestos. Technician B says that it is OK to blow brake dust with compressed air. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Identify the two refrigerant lines that are attached to the compressor.
A. The exhaust and intake lines B. The suction and discharge lines C. The turbo and induction lines D. The liquid and vapor lines
Analyze and evaluate the positive and negative impacts of the Industrial Revolution on American labor, on the rich and the poor, and on families and home life.
What will be an ideal response?