How many Ackerman arms would you find on a typical single axle truck steering system?
A. one
B. two
C. three
D. four
Answer: B
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The fundamental dimensioning rules are a set of general rules that apply to dimensioning and interpreting engineering drawings. 2. Where processing information is shown on a drawing, it should be labeled mandatory. 3. Unless otherwise specified, all tolerances apply in a free-state condition, except for non-rigid parts defined with a restraint note. 4. Unless otherwise specified, where a coordinate system is shown on a drawing, it shall be right-handed. 5. Where Rule #1 applies to an internal regular feature of size, the minimum boundary (or envelope) of the regular feature of size is equal to its largest size limit (MMC).
What is another name for data hub in a network system?
A. network star B. mainframe C. dumb node D. focal point
If a 10-inch block changes in length by 0.5 inches, what is the strain?
What will be an ideal response?
Which of the following is not one of the basic methods of engineering modeling?
A. wireframe B. surface C. photorealism D. solid modeling