After calculating a heat loss, what other information must be obtained before selecting a furnace model?
a. Heat content of fuel gas
b. Heating airflow
c. Outdoor design temperature
d. Latent heat load
b. Heating airflow
You might also like to view...
An IAC valve stuck in the closed position may cause all of the following except:
A. Stalling. B. Rough idle. C. High idle speed. D. Low idle speed.
Clams, mussels, oysters, and scallops fall into the ____________________ subcategory of shellfish
Fill in the blank(s) with correct word
If the cutting stream is too fast, ____.
A. the cutting stream may gouge the side of the cut B. the top edge may be melted or rounded off C. the cut may be incomplete D. the sides of the kerf may be dished
Bend allowance the amount of extra material needed for a bend to compensate for compression during the bending process.
Answer the following statement true (T) or false (F)