To obtain a direct drive ratio in a manual transmission this happens:
a. the input shaft drives the main shaft directly
b. the reverse idler is moved out of the way
c. the over drive ratio is sent back through the countershaft d. direct drive isn't possible
A
You might also like to view...
The highest AFUE-rated oil furnace that a technician is likely to encounter is _____.
a. 78 percent b. 80 percent c. 86.5 percent d. 95 percent
Neutral gear results when the input into a planetary gear set is holding a member.
Answer the following statement true (T) or false (F)
Technician A says that a keyway cut into a shaft is a potential stress raiser. Technician B says that oil holes in crankshafts are potential stress raisers. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says A TP sensor can be tested using a DMM, DSO, or scan tool. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B