Explain a pictorial assembly drawing.

What will be an ideal response?


Most mechanisms and structures are composed of several individual parts that are connected together into subassembly and assembly drawings (see Unit 33). Examples of three types of assembly drawings follow.

Trades & Technology

You might also like to view...

How should heat pump outdoor units be mounted in areas where snowfall accumulates?

What will be an ideal response?

Trades & Technology

When welding pipe for procedure qualification or welder qualification, tack welds may be placed at positions ________ where the test pieces are taken

A) approximately B) Located precisely C) Other than D) none of the above

Trades & Technology

How is placement of the compressor line determined when drawing a PH diagram of an operating system?

A) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant enthalpy lines up until it crosses the condenser line. B) The compressor line starts where the condenser line crosses the suction line temperature and follows the constant entropy lines up until it crosses the evaporator line. C) Measure the suction-line temperature entering the compressor. Find where the evaporator line crosses this suction line temperature in the superheated area. D) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant quality lines up until it crosses the condenser line.

Trades & Technology

According to ADA requirements for accessible water closets, the maximum height above the floor that controls

for flush valves and flushometers can be mounted is _____. a. 32 inches b. 36 inches c. 40 inches d. 44 inches

Trades & Technology