If suction pressure was too high what components would you check to determine if they were adjusted properly?
A. Suction service valve and receiver tank service valve.
B. TXV and accumulator.
C. TXV and suction pressure regulator.
D. Safety valve and discharge regulator.
Answer: C
Trades & Technology
You might also like to view...
A 2 × 4 sill plate runs around the floor in Figure 14.62. Determine the purchase quantity and number of board feet of 2 × 4 needed for the sill.
What will be an ideal response?
Trades & Technology
A well aerated soil is characterized by a relative abundance of ________
A) methane gas B) Fe2+ions C) NO3- ions D) micropores E) NH4+ ions
Trades & Technology
What battery rating is tested at 32°F?
A) Reserve capacity B) Cold-cranking amperes (CCA) C) Cranking amperes (CA) D) Battery voltage test
Trades & Technology
Hard spots in the drum care caused by over-heating the brakes.
Answer the following statement true (T) or false (F)
Trades & Technology