Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says that a TP sensor can be tested using a DMM (digital multimeter), DSO (digital storage oscilloscope), or scan tool. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both technicians
D) Neither technician
B
Trades & Technology
You might also like to view...
The American agricultural industry has become the most powerful and efficient in the world for what three basic reasons?
What will be an ideal response?
Trades & Technology
Describe the advantages in prefitting and prefinishing doors.
What will be an ideal response?
Trades & Technology
Which of these is the term used for electrical power?
A) Amps B) Watts C) Volts D) None of these
Trades & Technology
A vehicle that enters a road from a driveway:
a. has the right-of-way b. must stop and yield the right-of-way to traffic on the roadway and to pedestrians c. must yield to traffic approaching from the right, while it has the right-of-way over vehicles approaching from the left
Trades & Technology