A) ASE
B) ANSI
C) DOT
D) SAE
When a cad cell senses light, the resistance measured on the cell is very low.
Answer the following statement true (T) or false (F)
False
Trades & Technology
You might also like to view...
Based on the statistics of fatalities in building fires in the United States, which building type has the worst record?
A) Multifamily dwellings B) Hotel buildings C) One - and two-family dwellings D) Office buildings E) Industrial buildings
Trades & Technology
Assume that µ,h, and ? are measured independently and that the measurements are unbiased and normally distributed. The measured values are µ=1.6Pa ? s, h=15 mm, and ?=25 Pa. The uncertainties (standard deviations) of these measurements are 
=0.05, 
=1.0, and 
=1.0.
In a Couette flow, two large flat plates lie one atop another, separated by a thin layer of fluid. If a shear stress is applied to the top plate, the viscosity of the fluid produces motion in the bottom plate as well. The velocity V in the top plate relative to the bottom plate is given by V=?h/µ where ? is the shear stress applied to the top plate, h is the thickness of the fluid layer, and µ is the viscosity of the fluid.
a. Use the method of propagation of error (Section 3.3) to estimate V and its uncertainty?V.
b. Assuming the estimate of V to be normally distributed, find a 95% confidence interval for V.
c. Perform a simulation to determine whether or not the confidence interval found in part (b) is valid.
a. Use the method of propagation of error (Section 3.3) to estimate V and its uncertainty 
.
b. Assuming the estimate of V to be normally distributed, find a 95% confidence interval for V.
c. Perform a simulation to determine whether or not the confidence interval found in part (b) is valid.
Trades & Technology
A meter used to measure amperes is called a(an) _____________
A) Coulomb meter B) Ampmeter C) Ammeter D) Amp meter
Trades & Technology
All safety glasses should meet standards set by ________
Trades & Technology