A _____ section results when the cutting plane is parallel to the short axis of the structure.
A. longitudinal
B. partial
C. transverse
D. full
Answer: C
You might also like to view...
Technician A says that some outer CV joints can be serviced if the boot is torn and no noise is heard while driving. Technician B says that the ideal solution to outer CV joint failure is replacement of the entire CV axle. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
When diagnosing an electronic distributor ignition system, a 12-volt test light connected from the negative primary coil terminal to ground flutters while cranking the engine. A test spark tester does not fire when it is connected from the coil secondary wire to ground while cranking the engine. The cause of this problem could be a ________
A) Defective ignition coil B) Defective primary circuit C) Defective ignition module D) Defective pickup coil
What is the most important factor in controlling bacteria?
What will be an ideal response?
Pitch bearings are used to rotate the tower assembly.
Answer the following statement true (T) or false (F)