This is the smallest distance between two parallel planes within which the actual surface features are contained.
A. actual mating size
B. actual size
C. actual local size
D. none of the above
Answer: A
You might also like to view...
?What welding process didElihu Thomson develop in 1886?
A. ?Forge Welding B. ?Arc Welding C. ?Fusion Welding D. ?Resistance Welding
The landscape designer can place the same type of plant in different places to establish a ____________________
Fill in the blank(s) with correct word
A transistor with a height of 0.4 cm and a diameter of 0.6 cm is mounted on a circuit board. The transistor is cooled by air flowing over it with an average heat transfer coefficient of 30?W/m2•K. If the air temperature is 55°C and the transistor case temperature is not to exceed 70°C, determine the amount of power this transistor can dissipate safely. Disregard any heat transfer from the transistor base.
What will be an ideal response?
Answer the following statement(s) true (T) or false (F)
1. The fundamental dimensioning rules are a set of general rules that apply to dimensioning and interpreting engineering drawings. 2. Where processing information is shown on a drawing, it should be labeled mandatory. 3. Unless otherwise specified, all tolerances apply in a free-state condition, except for non-rigid parts defined with a restraint note. 4. Unless otherwise specified, where a coordinate system is shown on a drawing, it shall be right-handed. 5. Where Rule #1 applies to an internal regular feature of size, the minimum boundary (or envelope) of the regular feature of size is equal to its largest size limit (MMC).