What should 1 1/2 to 2-inches of clutch free pedal produce in free travel between the clutch release yoke fingers and the release bearing in a push type clutch?
A. zero lash
B. 1/8 inch (3 mm)
C. 1/4 inch (6 mm)
D. 1/2 inch (12 mm)
Answer: B
You might also like to view...
Two technicians are discussing brake warning lights. Technician A says that the brake warning light alerts drivers to problems with the braking system. Technician B says the light only reminds the driver to release the parking brake. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
The evaporator in a low-pressure chiller:
A) Operates between 5 and 10 psig. B) Operates between 10 and 50 psig. C) Is generally higher than the condenser pressure. D) Operates in a vacuum.
What controls when Shrader valves open and close?
A) They open when they are backseat cracked and close when they are backseated. B) They open every time the unit starts up and close immediately upon shutdown. C) They open and close when hoses with depressors are connected and disconnected to them. D) They open and close by a wireless Bluetooth signal.
A load consists of a parallel connection of R1-L1, R2-L2, and R3-C1 paths as shown below. Assume R1 = 60 ?, R2 = 55 ?, R3 = 50 ?, L1 = 55 mH, L2 = 75 mH, C1 = 200 ?F, |Vrms| = 105 V, f = 60 Hz. Find the complex power, average power, reactive power, apparent power, and power factor of each path. Also, find the complex power, average power, reactive power, apparent power, and power factor of the entire load.