Which of the following components can easily be modified for use as a pilot shaft for installing clutch assemblies?

A. clutch fork shaft
B. used transmission input shaft
C. used axle stub
D. transmission tailshaft


Answer: B

Trades & Technology

You might also like to view...

Saturated water with a quality of 0.55 and a temperature of 120°C enters an uninsulated diffuser at a velocity of 180 m/s. The mass flow rate is 1.5 kg/s.

(a) If the water is to exit as saturated water vapor at a temperature of 120°C, with negligible velocity, determine the necessary heat transfer rate. (b) Using your model of a diffuser, determine and plot the necessary heat transfer rates for the flow to exit as a saturated substance with qualities ranging from 0.65 to 1.0. Given: Water: x1 =0.55; T1 = 120°C; V1 = 180 m/s; x2 = 1.0; T2 = 120°C; V2 = 0; m?=1.5 kg/s What will be an ideal response?

Trades & Technology

Technician A says that any J1939 data bus can be accessed by connecting through a green 9-pin Deutsch connector. Technician B says that a J1939 data bus backbone can be accessed through a 3-pin Deutsch connector. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

The crew leader's primary job is to _____

a. make sure the crew is well-trained b. make sure the job is done correctly and on time c. prepare performance evaluations for crew members d. perform material takeoffs

Trades & Technology

Using the following definitions of lowpass, highpass, bandpass, and bandstop, classify the systems whose transfer functions have the pole-zero diagrams in Figure E.43. (Some may not be classifiable.) In each case the transfer function is H(z) .

LP: H (1) ? 0 and H (?1) = 0 HP: H (1) = 0 and H (?1) ? 0
BP: H (1) = 0 and H (?1) = 0 and H (z) ? 0 for some range of |z| = 1
BS: H (1) ? 0 and H (?1) ? 0 and H (z) = 0 for at least one |z| = 1

Trades & Technology