Too much primary air or will cause:
A) Flame rollout. B) Delayed ignition.
C) The high limit to open. D) Higher-than-normal temperature rise.
B
You might also like to view...
Suppose a circuit is designed to turn off a compressor if the pressure in the system reaches a predetermined level. If the pressure becomes high enough to cause the pressure switch contacts to close, ____.
a. the CR relay coil is turned off b. the compressor motor will connected to an auxiliary power line c. a warning light will be turned on d. compressor is automatically restarted by the thermostat
Which of the following fuel sub-system components is NOT under suction in a V-MAC III EUP fuel system?
A. fuel tank B. primary filter C. ECU D. secondary filter
When a sawtooth wave is applied to a differentiator op amp, the output is a(n) __________.
A. inverted and amplified sawtooth B. square wave C. sine wave
The U-value of any material or assembly is simply the reciprocal of the ____ of that material or assembly.
a. heat load b. temperature c. exposure d. R-value