Which of the following statements are true about flow manufacturing?
I. Work stations are located in the sequence needed to make the product.
II. Work flows at a relatively constant rate.
III. They can produce a wide variety of different products.
IV. There is little buildup of inventory.
A) I, III and IV are true.
B) I, II, III and IV are true.
C) I, II and III are true.
D) II, III and IV are true.
E) I, II and IV are true.
E
You might also like to view...
Before measurements can be taken using a temporary benchmark, you must calculate the _____.
a. height above sea level b. backsight distance c. height of instrument d. target location
Under what circumstances would a no-start condition occur?
What will be an ideal response?
What is the maximum hook to latch clearance permitted on a highway pintle hook assembly?
A. 3/8 inch (10 mm) B. 1/2 inch (12.5 mm) C. 3/4 inch (19 mm) D. 1-inch (25 mm)
A device typically used to allow the processor to select specific devices in the system is ________
A) a decoder B) a demultiplexer C) a shift register D) none of the above