Normally, a single part in an assembly is drawn alone on one sheet without any portion of the assembly shown. In some applications, it is necessary to show a part or parts that are next to the part being detailed. This is the related part method. Describe the related part method.

What will be an ideal response?


When this is necessary, the adjacent part is drawn using phantom lines to show its relationship with the part being detailed. This practice is usually done when there is a functional relationship between the parts, which needs to be specified in a note.

Trades & Technology

You might also like to view...

How many radial strokes are used to identify an SAE grade eight bolt?

A. one B. three C. six D. eight

Trades & Technology

When making a conduit-to-box connection and a bonding wire will be installed, use a _____.

a. standard locknut b. sealing locknut c. grounding locknut d. plastic locknut

Trades & Technology

The proper term for Channel Locks is ________

A) Crescent wrench B) Vise Grips C) Multigroove adjustable pliers D) Locking pliers

Trades & Technology

Pretreatment of boiler feedwater __________________

A. consists of heating, softening and reverse osmosis treatment, and is done to limit the amount of chemicals necessary B. consists of chemical treatment and is used to raise the Ph of the feedwater C. consists of chemical treatment and is used to lower the Ph of the feedwater D. is only used on large boilers operating for a power utility

Trades & Technology