During a stall test, what is the maximum time that full stall can be maintained before you have to allow the transmission a cool down period?
A. 20 seconds
B. 30 seconds
C. 45 seconds
D. 60 seconds
Answer: B
You might also like to view...
Explain how to construct an oblique drawing using the framing technique.
What will be an ideal response?
In a standard doorbell, the ____________________ and contact points are ungrounded, while the armature and terminal E are grounded to the case.
Fill in the blank(s) with the appropriate word(s).
Establishing Vocational Agriculture in public high schools was the main contribution of which of the following?
A. Land Grant Act of 1862 B. Smith-Lever Act of 1914 C. Smith-Hughes Act of 1917 D. No answers
When greasing a driveshaft U-joint, grease exits from three trunnion seals but not the fourth. What should be done next?
A. heat the trunnion with a rosebud B. loosen the bearing cap on the affected trunnion and try again C. remove the U-joint and hand pack each bearing cap D. replace the U-joint