Name four safety precautions you should bear in mind when operating a lift?

Question

What will be an ideal response?

Answer 1

1. If there are any problems with the lift, do not use it. See your supervisor immediately.
2. When lifting, first raise the vehicle until its wheels are about 6" off the ground. Then jounce the vehicle and double-check the contact between the adapters and the frame to be sure the vehicle is safely engaged.
3. Be certain that all four lift pads are contacting their lift points and bearing a load.
4. If a lift arm is positioned improperly, lower the vehicle slowly to the ground and reposition the arm.
5. When performing repairs to a vehicle raised on a frame-contact lift, do not use a large prybar or do anything else that might knock the vehicle off the adapters. When tight bolts are encountered, it is best to use an air impact wrench on them.
6. Be sure that the lift contact points on the vehicle are in good condition and free of oil or grease.
7. Some lifts have different length arms in the front than they do in the rear. These are called asymmetrical arms. Be sure to consult the manufacturer's instructions before using this type of lift.
8. Some lifts have a safety locking device to hold the post should a hydraulic failure occur. Be sure it is engaged.
9. The lift area should be clean with no grease or oil on the floor. Hoses, extension cords, and tools should be stored in the places where they belong.
10. Do not allow customers to drive their own car onto the lift.
11. Be sure that the lift has adequate capacity to lift the weight of the vehicle.
12. Be sure that the lift is all of the way down before attempting to drive a car on or off it.
13. Before lowering a vehicle, be sure to alert anyone nearby. Be certain that no tools or equipment are below the car. All of the car's doors should be closed.