How can the SCR be tested with an ohmmeter?
What will be an ideal response?
To test the SCR with an ohmmeter, connect the positive output lead of the ohmmeter to the anode and the negative lead to the cathode. The ohmmeter should indicate no continuity. Touch the gate of the SCR to the anode. The ohmmeter should indicate continuity through the SCR. When the gate lead is removed from the anode, conduction may stop or continue depending on whether the ohmmeter is supplying enough current to keep the device above its holding current level. If the ohmmeter indicates continuity through the SCR before the gate is touched to the anode, the SCR is shorted. If the ohmmeter will not indicate continuity through the SCR after the gate has been touched to the anode, the SCR is open.
You might also like to view...
According to the glass industry, a low-E coating in an insulating glass unit (IGU) is best placed on surface 2 in warm climates and surface 3 in cold climates. However, this recommendation is modified if the IGU also has a reflective coating. What is that recommendation?
What will be an ideal response?
Give three reasons why rootstocks are commonly used
What will be an ideal response?
A vacuum pump removes ____________________ and air from a refrigeration system.
Fill in the blank(s) with the appropriate word(s).
The mechanical power produced by an internal combustion engine is usually in the form of a ____________________
Fill in the blank(s) with correct word