On current trucks with data bus driven electronics, where should you place the ground clamp from a battery charger or jumper lead when boosting?

A. on the starter ground post
B. on the frame rail
C. directly on the alternator post
D. directly on the battery ground post


Answer: D

Trades & Technology

You might also like to view...

Adding material to or removing material from the original model can create a more complex model. When material is removed, a(n) ____________________ feature is created.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Two kilograms of air is expanded in a piston-cylinder arrangement at a constant pressure of 600 kPa from a volume of 0.1 m3 to a volume of 0.3 m3. Then the temperature is then held constant during an expansion to 0.5 m3. The total work done by the air is nearest:

A) 119 kJ B) 132 kJ C) 151 kJ D) 189 kJ

Trades & Technology

Which alignment angle is LEAST likely to cause tire wear?

A) Camber B) Caster C) Toe D) None of these is correct

Trades & Technology

A 240/24 volt - 40 VA transformer will supply up to ____ amperes from the secondary without a voltage reduction.

A. 1.257 B. 1.50 C. 1.666 D. 1.841

Trades & Technology