Denmark Vesey’s rebellion never came to fruition because __________
A) torrential rains made carrying out the plan impossible
B) Vesey changed his mind
C) one of his compatriots betrayed him
D) he was unable to create enough support to carry out the plan
Answer: C
You might also like to view...
Establish the wind pressures on the building in Problem P2.13 when the windward roof is subjected to an uplift wind force.
Problem 2.13
The dimensions of an enclosed gabled building are shown in Figure P2.13a. The external
pressures for the wind load perpendicular to the ridge of the building are shown in Figure
P2.13b. Note that the wind pressure can act toward or away from the windward roof surface.
For the particular building dimensions given, the C p value for the roof based on the ASCE
standard can be determined from Table P2.13, where plus and minus signs signify pressures acting toward and away from the surfaces, respectively. Where two values of C p are listed, this indicates that the windward roof slope is subjected to either positive or negative pressures, and the roof structure should be designed for both loading conditions. The ASCE standard permits linear interpolation for the value of the inclined angle of roof ?. But interpolation should only be carried out between values of the same sign. Establish the wind pressures on the building when positive pressure acts on the windward roof. Use the following data: basic wind speed = 100 mi/h, wind exposure category = B, K d = 0.85, K zt = 1.0, G = 0.85, and C p = 0.8 for windward wall and –0.2 for leeward wall.
A Quaternary ammonium compounds 1,000 part per million (p.p.m) is commonly used as disinfectant solution are also called:
What will be an ideal response?
To determine if a windshield wiper problem is electrical or mechanical, the technician should ________
A) Check to see if the fuse is blown B) Check the washer fluid for contamination C) Check the condition of the wiper blades D) Disconnect the linkage from the windshield wiper motor and operate the windshield wiper
Leaks on the low side of a Type III system are indicated by:
A) Puddles of refrigerant on the floor around the machine. B) Lower than normal system pressures. C) Increased purge operation. D) Oil stains around the leak from oil carried with the leaking refrigerant.