What is the purpose of checking the supply voltage after starting the system?
A) To determine the refrigeration coefficient of performance, crop
B) To determine which power leg is positive and which is negative
C) To verify that the supplied voltage is within the manufacturer's specifications
D) To determine the voltage drop in the wire
D
You might also like to view...
In a dual air brake system if one air system is very low on pressure
Air brakes
In a 60-cycle alternating electromotive force (emf), the angular velocity is 21,600° per second. What is the instantaneous voltage (e) at the end of exactly 0.04 seconds? The maximum voltage (Emax) is 580.0 volts. Round the answer to the nearest tenth volt.
Fill in the blank(s) with the appropriate word(s).
Show how you would use a single op amp to generate If the integrating capacitor is C = 5 ?F, obtain other component values.
What will be an ideal response?
When using a recovery device manufactured after November 15, 1993, the recovery level for Type I appliances is:
A) 80 percent of the system charge. B) 80 percent of the system charge if the compressor is nonoperational, 90 percent if the compressor is operational. C) 0 psig. D) 80 percent of the system charge if the compressor is operational, 90 percent if the compressor is nonoperational.