A taper can be specified on a drawing:
A. In degrees of taper
B. As a taper ratio
C. By notation that a standard industrial taper is required
D. By any of the ways described in a, b, and c above
Answer: D
Trades & Technology
You might also like to view...
Label the following furnace
Trades & Technology
Why must all skin areas be covered when welding?
What will be an ideal response?
Trades & Technology
When a component is used to perform the function of stop in a control circuit, it will generally be connected in ____________________ with the motor starter coil.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
What active test on a protocol analyzer is selected to see the path that the packets are traveling and the time it takes the packets to compete the trip?
a. Trace route. b. Route generator. c. Traffic generator. d. Packet internetwork groper (PING).
Trades & Technology