?In matched-mold design, the parameters are similar to ____.
A. ?compression molding
B. ?injection molding
C. ?liquid resin molding
D. ?fluid molding
Answer: A
You might also like to view...
When lightning or thunder is present _____.
a. lifting and rigging operations should be halted immediately b. lifting and rigging can proceed until radar indicates that lightning strikes are within 1 mile c. lifting and rigging can proceed until radar indicates that lightning strikes are within 3 miles d. lifting and rigging can proceed until radar indicates that lightning strikes are within 7 miles
Insulation lagging work would likely be found at a _____.
a. school b. petrochemical plant c. hospital d. big-box store
A balloon is a circle placed on the drawing with a part identification number inside the circle. While part identification on an exploded technical illustration commonly use circles with numbers inside as balloons, some companies prefer to use numbers without circles. Each balloon is connected to its related part with a leader line. The balloon part identification number correlates to the same number identifying the part in the parts list. The parts list identifies every part in the assembly.
Answer the following statement true (T) or false (F)
Compared to sanitary sewers, storm sewers are usually
a. in shallower trenches b. of smaller pipe diameter c. less efficient d. in deeper trenches e. none of the above