In the ____ system, the small diameter electrode wire must have enough stiffness to be pushed through the conduit without kinking.
A. pull-type
B. push-type
C. push-pull-type
D. spool gun type
Answer: B
You might also like to view...
Which of the symbols shown in the figure above is normally used to indicate a separate pilot light?
a.
b.
c.
d.
A 74.6-kW, three-phase, 440-V (line to line), four-pole, 60-Hz induction motor has the following (per-phase) parameters referred to the stator circuit (see Figure 19.36):
RS = 0.06 ? XS = 0.3 ? Xm = 5 ?
RR = 0.08 ? XR = 0.3 ?
The no-load power input is 3,240 W at a current of 45 A. Determine the line current, input power, developed torque, shaft torque, and efficiency at s = 0.02.
It takes an experienced CAD drafter 24 hours to complete a set of working drawings. Another CAD drafter takes 48 hours to complete a similar set of working drawings. What is the ratio of the first CAD drafter's time to the second CAD drafter's time?
What will be an ideal response?
Use the following engine dimensions to calculate the compression ratio
Bore: 5.000 in. Stroke: 6.000 in. Clearance Volume: 7.91 in^3 A) 15.9:1 B) 16.2:1 C) 15.6:1 D) 16.5:1