Cylinder taper and out of round should be measured ________
A) Just below the ridge B) Near the bottom of piston travel
C) Both A and B D) Neither A nor B
C
Trades & Technology
You might also like to view...
Specifically describe how NZ4 is attached to the tank.
Refer to Drawing Numbers T6592ML R0, T6593ML R0, and T6594ML R0.
Trades & Technology
Is land damage a result of poor land policies that came to the attention of public leaders in the United
States around 1850?
Indicate by YES (Y) or NO (N).
Trades & Technology
In order to save a bit of maintenance down the road, but perhaps more importantly, to avoid customer
complaints about ‘dying plants,’ ____ prior to installation can be a good practice.
a. putting a layer of mulch over the soil b. cleaning or waxing leaves on plants c. removing older leaves from plants d. using an insecticidal oil spray on plants
Trades & Technology
3.5
A) 35% B) 350% C) 0.035% D) None of these
Trades & Technology