Stock allowance in inches, for hand reaming should be between:

A) .001 to .005 in. B) .016 to .020 in. C) .006 to .010 in. D) .011 to .015 in.


A

Trades & Technology

You might also like to view...

Why are capacitors useful in power factor correction?

What will be an ideal response?

Trades & Technology

If two 10-ohm resistors are connected in series, what is the total resistance of these resistors?

a. 100 ohms b. 20 ohms c. 5 ohms d. 1 ohm

Trades & Technology

In a DC motor, the ___________ rides on the commutator to make an electrical connection between the rotating member and the stationary part of the motor

a. armature b. carbon brush c. stator

Trades & Technology

Which of the following would not be found in a PC?

A) RIMMs B) PIMMs C) SIMMs D) DIMMs

Trades & Technology