____, represented by alternating short and long dashes, cannot be seen on the real object, but they must be included on the drawing to identify where the center of the circular hole is located on the object.
A. Cross marks
B. Centerlines
C. Centermarks
D. Hidden lines
Answer: B
You might also like to view...
What is the typical maximum air inlet restriction pressure on a boosted engines?
A. 5inH2O vacuum B. 50inH2O vacuum C. 15inH2O vacuum D. 25 inH2O vacuum
Is heat-strengthened glass (HSG) safety glass like the tempered glass (TG)? Does spontaneous breakage occur in HSG?
What will be an ideal response?
Upon what three supports did royal ideology claim royalty rested?
a. workers, warriors, and priests b. warriors, kings, and scribes c. women, warriors, and workers d. priests, warriors, and scholars
What type of compressor clutch is likely used on a current A/C compressor?
a.wet type clutch b.centrifugal type clutch c.rotating coil type clutch d.stationary coil type clutch