Which part is clamped between the pressure plate and the flywheel?

A) Release bearing B) Clutch disc C) Pilot bearing D) Throwout bearing


B

Trades & Technology

You might also like to view...

Technician A says that Monotherm pistons are manufactured with a much tighter fit to the liner bore than aluminum trunk pistons. Technician B says that Monotherm pistons do not require an oil spray jet aimed at the underside of the piston. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

Technician A says that TOOT is the last adjustment made in a four wheel alignment. Technician B says that TOOT is a diagnostic angle that is not adjusted in a typical alignment. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

Regenerative braking uses the inertia of the vehicle to recapture energy during braking. Where is this recaptured energy stored?

A) In the high voltage battery bank B) In large resistors C) In the 12 volt battery bank D) In the electrohydraulic master cylinder

Trades & Technology

Another technician will be mixing soap and water to clean a vehicle. The soap is diluted 1-part soap to 50 parts water. Four gallons of water is in the bucket. How much soap should be put in the water?

What will be an ideal response?

Trades & Technology