Describe the practice of showing the multiviews of the part representing the final bent condition, and the flat pattern reference drawn on one of the views using phantom lines.
What will be an ideal response?
This option for a sheet metal part is for the multiviews of the part representing the final bent condition, and the flat pattern reference drawn on one of the views using phantom lines. For example, a multiview drawing of a final bent sheet metal part dimensioned using unidirectional dimensioning. The flat pattern reference is shown extended from the front view using phantom lines and is labeled for reference. This application is an option used by some companies, but it is one of the least common methods for drawing a sheet metal part.
You might also like to view...
Backlash is normally ________.
A) 0.008 -0.012 inch (0.2-0.3 mm) B) 0.100 -0.120 inch (2.5-3.0 mm) C) Less than 0.008 inch (0.2 mm) D) 0.012-0.020 inch (0.3-0.5 mm)
When an oxygen cylinder is exposed to fire, what device is used to reduce the possibility of an explosion?
A. rupture disc B. fusible plug C. flashback arrester D. backfire arrester
In the hexadecimal number system, ________ is the base ten equivalent of 12
A) A B) B C) C D) D
Carry the answer to five decimal places. A carbon brush measures 
inch thick and 
inches wide.It is to have a copper plating on all sides 0.015 inch thick. What will be the finished width in decimal form of the brush with the copper plating?
Fill in the blank(s) with the appropriate word(s).