Dimensions on prints are made up:
A. the extension lines
B. dimension lines
C. dimension numerals
D. none of the above
E. all of the above
Answer: E
You might also like to view...
____________________ losses traditionally made up about 66% of the power losses in the I2R losses of the stator windings.
Fill in the blank(s) with the appropriate word(s).
Technician A says that a drill is usually needed to remove a rivet. Technician B says that the most common rivet is a pop rivet. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Any time a fuse is replaced or a breaker is reset, which of the following should be checked before operating the system?
A) Check the main power wire connections. B) Check all major line voltage loads for shorts or grounds. C) Run the system and check the amp draw on the circuit to the unit and at each major load. D) All of these should be checked.
Which of the following materials are considered lightweight metals?
a. Aluminum b. Titanium c. Magnesium d. All of the above