Which of the following is a consequence of choosing the wrong code or standard for a job?
A. The cost of fabrication is lowered.
B. The quality of the weld is improved.
C. The cost of fabrication may be too high.
D. There is no consequence of choosing the wrong code or standard.
Answer: C
You might also like to view...
Springs that have been overheated will stretch and be longer.
Answer the following statement true (T) or false (F)
One table found on many framing squares helps to calculate the ____________________ feet in a
piece of lumber.
Fill in the blank(s) with the appropriate word(s).Which component of a rack and pinion steering gear is connected to the steering shaft?
A) The rack B) The left tie rod C) The pinion D) The rack support
The subsequent problems deal with the circuit below where the op amps are LM741's powered by a ±15 V power supply. Assume R1 = R2 = R3 = R4 = R. Assume the op amps are ideal.
If V1 = 1 V, V2 is
A. ?1 V B. 0 V C. 2 V D. ?2 V E. 1 V