The use of an electronic throttle control (ETC) system allows the elimination of all of these EXCEPT ________

A) Idle air control B) Mechanical throttle cable (most systems)
C) Cruise control actuator D) Accelerator pedal


D

Trades & Technology

You might also like to view...

Answer the following statement(s) true (T) or false (F)

1. Most access control systems are connected to the buildings network through a CAT 5 cable. 2. Wiring and cabling for all access control systems must comply with Article 300 of the National Electrical Code. 3. Most door and window contacts are “normally closed”. 4. The installation of class two power sources must comply with Article 725 of the National Electrical Code. 5. The type of sensing device to use in a access control systems typically depends on the layout of the building and the detail in which you need protection.

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. No one knows when the first battery was invented. 2. John Daniell did experiments in an attempt to improve the voltaic battery. 3. Primary cells are used for storage batteries. 4. A lead acid battery changes its chemical properties in different states. 5. A battery is typically rated in ohms.

Trades & Technology

In the accompanying figure, the item identified as number 3 refers to the ____.

A. T.V. B. L.V. C. F.V. D. B.V.

Trades & Technology

Excessive positive camber will cause tire wear ________

A) On both tire edges B) On the outside shoulder of the tire C) In the middle of the tire D) On the inside shoulder of the tire

Trades & Technology