Briefly describe rectangular coordinate dimensioning practice.
What will be an ideal response?
Rectangular coordinate
dimensioning is where linear dimensions are used to locate features from planes,
centerlines, or center planes.
You might also like to view...
The Acceptance Criteria for Bend Test requires that the sum of the greatest dimensions of all indications on the surface which exceed 1/32 in. (0.8 mm) but are less than or equal to 1/8 in. (3.2 mm) shall not exceed _____ in.
A. 1/8 B. 2/8 C. 3/8 D. 4/8
Answer the following statement(s) true (T) or false (F)
1.Before SPC operators would adjust their equipment based upon current readings. If the reading is taken when the processes normal variation is in a low cycle the operators adjustment will swing the process variable high. Adjustments made without SPC methodology tend to make the process swing high and low. 2.In any process a certain amount of variability can be found. Variability is defined as the tendency to vary. SPC identifies this variability and enhances an operators ability to control the process. 3.SPC allows the normal fluctuations on the equipment to be considered over a longer period of time. Sample results must demonstrate a downward or upward trend above the key target set points.
Express 4.1 quarts as ounces. Round the answer to the number of significant digits as in the original quantity.
Fill in the blank(s) with the appropriate word(s).
Would electric heat most likely be placed under electrical, plumbing, or HVAC?
What will be an ideal response?