Determination of an inductor's value can be had by what method(s)?
A) Connect the inductor in series with a known value of resistance, apply a square wave of a known voltage value, then use the time constant formula.
B) Apply a signal of a known frequency and voltage, then use Ohm's law and the inductive reactance formula.
C) Use an inductance meter.
D) any of the above
D
You might also like to view...
With a ____, design software identifies areas of high stress or large displacements in a model that could be modified to improve performance.
A. Remeshing Analysis B. Design Check C. Load Application D. Design Modification
A(n) ____ is used to connect a lead from a component or connect a wire from an off-board component.
A. paper doll B. jumper C. autorouter D. pad
What information is usually found on elevation drawings?
A. vertical side of a building B. plan view of a building C. air conditioning unit D. plumbing and electrical
If a thermostat fails in the open position, all of the following will occur, EXCEPT:
A. A loss of engine coolant. B. A longer than normal warm-up period. C. Poor heater performance. D. A vehicle may fail emissions test.