Refer to Problem 9.38. Assume:
|io|avg = 600 mA |vo|avg = 50 V
Vr = 8% = 4V
vline = 170 cos(?t) V ? = 377 rad/s
Determine:
a. The turns ratio n.
b. The capacitor C.
Problem 9.38
In the full-wave power supply shown in Figure P9.38 the silicon diodes are 1N4001 with a rated peak reverse voltage of 25 V.
n = 0.05883
C = 80 ?F Ro = 1 k?
vline = 170 cos(377t) V
a. Determine the actual peak reverse voltage across each diode.
b. Explain why these diodes are or are not suitable for the specifications given.
Analysis:
You might also like to view...
Why do some electricians prefer to use a plunger type voltage tester?
What will be an ideal response?
The NEC® specifies the minimum radius of conduit bends because _____.
a. installation of additional pull boxes is more efficient b. bending equipment cannot produce tighter bends c. the insulation on conductors could be damaged as it is pulled d. the internal diameter of the conduit may be increased
Collecting useful information and checking to determine if a product already exists that closely meets the needs of your client are parts of which phase in the engineering design process?
a. Recognizing the need for a product or service b. Problem definition and understanding c. Research and preparation d. Conceptualization
A(n) ____________________ is a device that displays the measurement of a monitored system by the use of a needle or pointer that moves along a calibrated scale.
Fill in the blank(s) with the appropriate word(s).