If "grinding in" or truing the grinder chuck becomes necessary, how do you determine when the surface has been trued?
A) Apply pencil lines to the chuck and grind until they disappear
B) Grind and then indicate
C) Don't grind the chuck, use shims instead
D) You just uniformly take .001 in. off the surface
A
You might also like to view...
Most weeds have many _____, which enables them to spread very rapidly
a. flowers c. leaves b. seeds d. stems
When using a brazing flux, it should be applied _____
a. only to the tube end b. to both the tube end and the fitting cup c. only to the fitting cup d. both before and after the brazing process
A truck equipped with air-over-hydraulic brakes has illuminated a dash-warning light indicating excess brake lining wear. What would generate this signal?
A. the brake system ECU B. the rear drums C. ABS sensor D. brake pedal
OBD II systems are highly efficient and only illuminate the malfunction indicator light (MIL) when an emissions failure has occurred that will raise emission levels 50 percent above the FTP levels.
Answer the following statement true (T) or false (F)